Planet-technology Bridge/Router ADU-2100 Uživatelský manuál

USB ADSL Modem ADU-2100 User’s Manual

6 Driver Installation for both LAN and WAN mode with Windows ME 1. The “Found New Hardware Wizard” will be displayed. Insert ADU-2100 driver CD and

7 3. Click Finish to complete ADU-2100 driver installation. Driver Installation for both LAN and WAN mode with Windows 2000 1. The “Add New Hardw

8 2. Choose the “Search for a suitable driver for my device (recommended)”, and click Next. 3. Next you will be prompted for software drivers. Se

9 5. The Found New Hardware Wizard will then find the ADSL USB MODEM, click Next.

10 6. The “Digital Signature Not Found” window will pop-up, Click Yes. 7. Click Finish to complete the installation.

11 Driver Installation for both LAN and WAN mode with Windows XP 1. The “Add New Hardware Wizard” will be displayed. Choose Install from a list or s

12 3. The Hardware Installation window appears. You will be asked; Do you want to continue installation? Click Continue Anyway. . 3. At the co

13 Driver Installation for both LAN and WAN mode with Windows 2003 Server 1. The Found New Hardware Wizard will appear. Select Install from a list

14 3. The Hardware Installation window appears. You will be asked; Do you want to continue installation? Click Continue Anyway. 4. At the conclus

15 Chapter 3 ADSL Configuration ADSL LAN Configuration 1. Conexant Access Runner ADSL icon should be added in the control panel or on the desktop

Copyright Copyright (C) 2003 PLANET Technology Corp. All rights reserved. The products and programs described in this User’s Manual are licensed prod

16 3. Press Alt + P on the keyboard, the right figure appears. 4. Under the Protocol Setup please set the value of VCI, VPI and Encapsulation.

17 6 IP Address setting: select Specify an address, then enter the value of IP Ad-dress and Subnet Mask obtained from ISP. 7. Gateway setting: e

18 8. DNS Configuration setting: Select Enable DNS, enter Host name and add DNS Server Search Order. Click Add and OK. 9. Reboot computer to act

19 ADSL WAN configuration 1. After driver installation, Conexant Access Runner ADSL and AccessRunner DSL icon should be added in the control panel a

20 5. Click the Access Runner DSL icon on the desktop -> enter User name, Password and Phone number (don’t care; recommend “0000”) fro

Revision User’s Manual for PLANET USB ADSL Modem Model: ADU-2100A / ADU-2100B Rev: 1.0 (JUL. 2003) Part No.: EM-ADU2100V1.doc

TABLE OF CONTENTS CHAPTER 1 INTRODUCTION...1 FEATURES...

1 Chapter 1 Introduction PLANET USB ADSL modem ADU-2100 is designed to provide cost-effective ac-cess to high-speed ADSL services. With our ADSL m

2 System Requirement l Mainboard with USB support l Pentium II CPU and above or compatible l RAM: 64M or above l Windows 98, Windows 2000, Windows M

3 Chapter 2 Installation Please refer to the following steps to complete ADU-2100 installation. Hardware Installation 1. Turn on your PC 2. Inser

4 3. Choose Specify a location. Then click Next. If you need to set for LAN mode (RFC1483), select LAN subdirectory and for WAN mode (RFC2516/23

5 4. The Add New Hardware Wizard will appear and indicate the PLANET ADU-2100 USB ADSL Interface has been recognized and will install a new drive